Chapter 5 Shooting — Adjustable settings when shooting
- 113 -
Operation of area mode function
The function set in the [CAMERA] menu → [SW MODE] → [AREA MODE] can be used by performing the following operation when shooting or while in
shooting standby.
1 Either press the USER button assigned to [AREA] or touch the USER button icon. (l 46)
≥ The area frame A is displayed, and the is displayed on the right side of the screen.
≥ When the area brightness display is activated, the brightness display in the center does not operate.
2 Touch the shooting screen.
≥ The area frame is displayed in the area that is touched to apply the effects set in the menu.
3 Press the USER button or the USER button icon
*
again.
≥ The area frame disappears and the unit exits the area mode function.
* To display the USER button icon, touch and hold the screen.
∫ Adjusting the area size
1 Turn the multidial to display the [ AREA].
2 Press the multidial.
3 Turn the multidial to change the size of the area frame.
It changes in 3 stages.
4 Press the multidial.
The setting is changed to the displayed size and exits.
The setting is changed and exits also by pressing the <EXIT> button.
0 The area mode function is cancelled when the power is turned off or when the thumbnail screen is displayed.
0 The area mode cannot be used when the digital zoom is enabled.
AREA
To Next Page
Loading...
