Chapter 5 Shooting — Audio input
- 125 -
Audio input
The unit can record 2 channels of audio.
When the handle unit ( / / supplied) is attached to the unit, you can connect audio equipment or an external microphone to the
<INPUT 1>/<INPUT 2> terminals.
The audio to input to each channel can be switched to the built-in microphone, an external microphone, or a connected audio device.
Switching the audio input
∫ Audio recording format
The audio recording format such as compression format varies depending on the [FILE FORMAT].
*1 Available for setting when using .
*2 When the setting in the [SYSTEM] menu → [REC FORMAT] is the following, this will be 48 kHz/16 bit.
j [1080-59.94p/AVC-G12], [1080-50.00p/AVC-G12], [1080-59.94i/AVC-G12], [1080-50.00i/AVC-G12], [720-59.94p/AVC-G12], [720-50.00p/AVC-G12]
When the setting in the [SYSTEM] menu → [REC FORMAT] is the following, 48 kHz/16 bit or 48 kHz/24 bit can be selected in the [SYSTEM] menu → [AUDIO
SAMPLE RES.].
j [1080-59.94i/AVC-I100], [1080-50.00i/AVC-I100], [720-59.94p/AVC-I100], [720-50.00p/AVC-I100], [1080-59.94i/AVC-I50], [1080-50.00i/AVC-I50],
[720-59.94p/AVC-I50], [720-50.00p/AVC-I50]
∫ Selecting audio input signals (When the handle unit is attached to the unit)
Selects the audio signal to record in the audio channel 1/audio channel 2.
[FILE FORMAT] Recording format Sampling rate/bit
[P2]
*1
Linear PCM (LPCM) 48 kHz/24 bit
*2
[MOV] Linear PCM (LPCM) 48 kHz/24 bit
[MP4] AAC 48 kHz/16 bit
[AVCHD] Dolby Audio
™
48 kHz/16 bit
A CH1 SELECT switch
B CH2 SELECT switch
CH1 SELECT switch setting CH2 SELECT switch setting
Input signal to be recorded
Audio channel 1 Audio channel 2
<INT/MIC (L)> <INT/MIC (R)> Built-in microphone <L>/<MIC> terminal
Lch
Built-in microphone <R>/<MIC> terminal
Rch
<INPUT1> Built-in microphone <L>/<MIC> terminal
Lch
<INPUT 1> terminal
<INPUT2> Built-in microphone <L>/<MIC> terminal
Lch
<INPUT 2> terminal
<INPUT1> <INT/MIC (R)> <INPUT 1> terminal Built-in microphone <R>/<MIC> terminal
Rch
<INPUT1> <INPUT 1> terminal <INPUT 1> terminal
<INPUT2> <INPUT 1> terminal <INPUT 2> terminal
CX7
CX10
CX10
To Next Page
Loading...
