Chapter 4 Operation — Menu settings
- 85 -
[CLEAR ACTIVATION]
Clears the activation license information that is saved.
The items that can be selected are as follows.
≥ [YES], [NO]
[WLAN PROPERTY]
Performs settings related to the wireless LAN.
[TYPE]
Sets the connection method to the wireless LAN.
(Factory setting: [DIRECT])
[SSID]
Enters or displays the network name of this unit or the wireless access point (SSID).
Select the following items to set this unit’s SSID.
≥ The [NETWORK] menu → [WLAN PROPERTY] → [TYPE] → [DIRECT]
Enter the SSID for this unit using 32 characters or less.
≥ Factory default value for this unit’s SSID:
The model number of the unit you are using is set. (For example: [AG-CX10], etc.)
[CHANNEL]
Sets the channel to be used when connected to the wireless LAN with following items set.
≥ The [NETWORK] menu → [WLAN PROPERTY] → [TYPE] → [DIRECT]
The items that can be set are as follows.
≥ [AUTO], [CH1], [CH6], [CH11]
(Factory setting: [AUTO])
[ENCRYPTION]
Sets the encryption method when the [NETWORK] menu → [WLAN PROPERTY] → [TYPE] → [INFRA(SELECT)]/[INFRA(MANUAL)] is selected.
The items that can be set are as follows.
≥ [WPA-TKIP], [WPA-AES], [WPA2-TKIP], [WPA2-AES], [NONE]
(Factory setting: [WPA2-AES])
0 The setting is fixed to [WPA2-AES] when the [NETWORK] menu → [WLAN PROPERTY] → [TYPE] → [DIRECT] is set.
[ENCRYPT KEY]
Sets the encryption key. Set the key using a string of 8 to 63 characters or a hexadecimal number with 64 digits.
(Factory setting: [01234567890123456789abcdef])
[WLAN IPv4 SETTING]
[DHCP]
Sets whether to use the automatic acquisition through DHCP or to use the DHCP server function of the unit.
(Factory setting: [OFF])
[IP ADDRESS]
Sets the IP address.
(Factory setting: [192.168.0.1])
0 Cannot be set when [WLAN IPv4 SETTING] → [DHCP] → [CLIENT] is selected.
[SUBNET MASK]
Sets the subnet mask.
(Factory setting: [255.255.255.0])
0 Cannot be set when [WLAN IPv4 SETTING] → [DHCP] → [CLIENT] is selected.
[DIRECT] It can connect directly without using a wireless access point to a device equipped with wireless LAN such as a tablet terminal.
[INFRA(SELECT)] Connects to the wireless access point. The access point is selected from the list.
[INFRA(MANUAL)] Connects to the wireless access point. Wireless access point is entered manually.
[OFF] Does not use DHCP.
[CLIENT]
Performs automatic acquisition through DHCP if connecting by setting [WLAN PROPERTY] → [TYPE] → [INFRA(SELECT)]/
[INFRA(MANUAL)].
[SERVER] Enables the DHCP server function of the unit when connecting by setting [WLAN PROPERTY] → [TYPE] → [DIRECT].
To Next Page
Loading...
