To Next PageTo Next Page
Need help?Do you have a question about the Panasonic AG-DVC180BMC and is the answer not in the manual?
General| Recording Media | MiniDV Tape |
|---|---|
| Recording System | DV |
| Maximum Aperture | f/1.6 |
| Filter Diameter | 72 mm |
| Media Type | MiniDV |
| Video Signal | NTSC |
| Viewfinder | Color LCD |
| Battery Type | Lithium-ion |
| Sensor Type | 3CCD |
| Sensor | 3CCD |
| Shutter Speed | 1/60 - 1/8000 sec |
| Gain | 0dB, 3dB, 6dB, 9dB, 12dB, 18dB |
| Recording Format | DV |
| Audio Recording | 16-bit PCM |
| LCD Screen | 2.5 inches |
| Video Output | Composite, S-Video |
| Audio Input | XLR |
Details periodic maintenance servicing to maintain the equipment's best condition and performance.
Provides a method for manually ejecting the tape when normal operation fails due to system trouble.
Details the procedure for removing the top panel unit, including screw and connector disconnections.
Explains the steps to remove the VF CASE L Unit, involving screws and connector disconnection.
Provides instructions for removing the Grip Unit, detailing screw removal and component access.
Describes the process for removing the mechanism unit and VTR C.B.A., including connector disconnections.
Details the procedure for removing the Handle Unit, involving screws and connector disconnection.
Explains how to remove the EVF Unit, including lifting and unscrewing steps.
Provides instructions for removing the Side Case R S Unit, detailing screws and connector disconnections.
Describes the steps to remove the LCD Unit, involving shield plate, hinge cover, and connector.
Details the procedure for removing the CAMERA C.B.A., including connector handling.
Explains how to remove the Lens Unit, involving the CAMERA C.B.A. and screws.
Provides instructions for removing the Zoom Motor Unit, including soldering and screws.
Details the process for removing the Back Case Unit, involving multiple screws and connector disconnections.
Explains how to remove the BACK CONNECT C.B.A. after other units are removed.
Covers tape transportation names, tape path adjustment procedures, and EVR tool confirmation.
Details the adjustment of S1 and T2 posts for LISTA linearity and Envelope waveform.
Explains the connection of the LISTA adjustment system, including PC, measuring board, and camera.
Details the procedure for performing LISTA sensitivity detection and confirming values.
Explains LISTA linearity adjustment using S1 and T1 post height adjustments.
Contains procedures for various camera adjustments like zoom, white balance, and shading.
Details VTR adjustments including tape sensor sensitivity, PG shifter, and level adjustments.
Lists electrical components such as capacitors, resistors, diodes, and ICs for replacement.
