Panasonic AG-DVC180BMC

INF-1
1. SERVICING FIXTURES AND TOOLS
The following servicing tools are required for mechanical and electrical servicing and alignment.
The items marked “NEW” in the following list are necessary for the AG-DVX100B/102B/DVC180B.
Please refer to “Y” and “N” in column of table below, which tools required for servicing the NTSC and PAL model.
Please refer to “Y” in column of table below, these tools were also use for servicing the AG-DVX100A/DVC180A.
1-1. Summary Table of Servicing Fixtures and Tools
No
Parts No. NAME
NTSC
Model
PAL
Model
AG-DVX100A/
DVC180A
REMARK
1 VFM3010EDS DV Alignment Tape (Color bar) Y N Y
2 VFM3110EDS DV Alignment Tape (Color bar) N Y Y
3 VFM3000LS DV Alignment Tape (Linearity) Y Y Y
4 *VVS0026 EVR Adjustment Software Y N N NEW
Download from the WEB site.
5 *VVS0027 EVR Adjustment Software N Y N NEW
Download from the WEB site.
6 *VFK1481N LISTA Software Y Y Y Download from the WEB site.
7 VFK1308P Measuring Board Y Y Y
8 VFK1309A EVR Connector Board Y Y Y Enable to use with VFK1309
9 VFK1763 Connector Adapter Y Y N 60-30pin.
It uses with AG-DVC30/32/33
and AG-DVC60/62/63.
10 VFK1982 Extension Cable Y Y N NEW
11 VJA0941 DC Cable Y Y Y 2 pieces Required
12 VFK1317 30pin Flat Cable Y Y Y 2 pieces Required
13 VFK1809 72mm Attachment Ring Y Y Y
14 VFK1164TAR43 43mm Attachment Ring Y Y Y
15 VFK1164TCM01 Collimator Set (Infinity Lens) Y Y Y
16 VFK1345 CC Filter Holder Y Y Y
17 VFK1346 Step Down Ring Y Y Y
18 VFK1659 Step-Up Ring (43mm-49mm) Y Y Y
19 VFK1660 Step-Up Ring (49mm-62mm) Y Y Y
20 VFK1341 CC Filter (LB40) Y N Y
21 VFK1342 CC Filter (LB80) N Y Y
22 VFK1347 CC Filter (LB120) Y Y Y
23 VFK1884 CC Filter (LBA2) Y Y Y
24 VFK1888 CC Filter (LBB6) Y Y Y
25 VFK1885 CC Filter (LBB2) Y N Y
26 VFK1886 CC Filter (CC C10) N Y Y
27 VFK1887 CC Filter (CC C20) N Y Y
28 VFK1409A Measuring Board Y Y Y NOTE 1
29 VFK1899 Post Driver Y Y N NOTE 2
It uses with AG-DVC30/32/33
and AG-DVC60/62/63.
30 VFK1810 LISTA Measuring Board Y Y Y NOTE 1
31 VFK1186 LISTA Cable Y Y Y
32 VFK1300 A/D Converter Board Y Y Y ISA PC Board.
NOTE:
1. If you already have VFK1409S, it can be used for LISTA adjustment with VFK1810 instead of VFK1409A.
(Refer to item “1-5. Connection of LISTA Adjustment system” on page MECH-4 in section 3.)
2. This Post Driver use for servicing the “A” mechanism of consumer model.