Panasonic AG-UX90EJ - Record Setup

27
RECORD SETUP
Menu item
Description
Value
(Factory default setting underlined)
MEDIA SELECT
Select media slot for recording.
SD CARD1 / SD CARD2
2SLOT FUNC.
Set the record mode, which uses
dual memory card slots.
OFF / RELAY / SIMULTANEOUS /
BACKGROUND(*1) / DUAL
CODEC(*1) See P. 37 for the
details. *1: AG-UX180 only
DUAL CODEC REC
(AG-UX180 only)
Select the codec for sub
recording. Available in DUAL
CODEC mode only.
FHD 50Mbps / FHD 8Mbps
INTERVAL REC
Set record interval time (pause
time) of time-lapse recording.
OFF / 1SEC / 10SEC / 30SEC /
1MIN / 2MIN
VFR MODE
Turn ON/OFF variable frame
record mode.
ON / OFF
FRAME RATE
Adjust frame rate. Adjustable
range is from 2fps to 50fps
25fps
SUPER SLOW
(AG-UX180 only)
Record at 120fps (59.94Hz
mode)or 100fps (50Hz mode)
ON / OFF
PRE-REC
Turn ON/OFF pre-record mode.
This mode allows the camera to
start recording the video and
audio (approx. 4 sec in the
MOV/MP4 mode, 3 sec in the
AVCHD modes) before the REC
button is pressed.
ON / OFF
INFRARED REC
(AG-UX180 only)
Turn ON/OFF the infrared record
mode, allowing image capture in
dark locations.
ON / OFF
IR REC COLOR
(AG-UX180 only)
Set color of video image in
INFRARED REC mode
Green / White
FOCUS TRANSITION
(AG-UX180 only)
Register positions for focus
transition function. (See P.41)
SET / OFF
FOCUS TRANSITION
TIME(AG-UX180 only)
Set transition time from one
position to another.
Direct/ Fastest / 2 – 15sec / 20sec /
30sec / 45sec / 60sec / 90sec
FOCUS TRANSITION
REC
(AG-UX180 only)
Execute the focus transition
function as soon as REC button
is pressed. This menu item
selects which position to start
with.
1 / 2 / 3 / OFF
FOCUS TRANSITION
WAIT(AG-UX180 only)
Set pause time until focus
transition starts.
0sec / 5sec / 10sec
TIME STAMP
Allows recording of
superimposed date and time on
the image.
ON / OFF
DF MODE
Set timecode drop frame mode.
DF / NDF
TCG
Set timecode count mode.
FREE RUN / REC RUN
TC PRESET
Set initial value of timecode.
--
UB PRESET
Set value of users bit
Available in AVCHD mode only.
EXT TC LINK
(AG-UX180 only)
This item is for timecode
synchronization for multi camera
recording purpose. (see P.38)
MASTER / SLAVE
3. MENU settings