21 SYSTEM CAM
FORMAT
“FORMAT” (see page 39)
CROP OUT
“CROP OUT” (see page 39)
CROP MARKER
“CROP MARKER” (see page 39)
CROP ADJ
“CROP ADJ” (see page 39)
CROP H POS (%)
“CROP H POS (%)” (see page 39)
CROP V POS (%)
“CROP V POS (%)” (see page 39)
GEN LOCK INPUT
“GEN LOCK INPUT” (see page 39)
GEN LOCK COARSE
“GEN LOCK COARSE” (see page 39)
GEN LOCK FINE
“GEN LOCK FINE” (see page 39)
SHOOTING MODE
“SHOOTING MODE” (see page 39)
22 CAMERA MENU CONTROL
MENU ON/OFF
“MENU ON/OFF” (see page 40)
CURSOR/PARAMETER
“CURSOR/PARAMETER” (see page 40)
EXECUTE
“EXECUTE” (see page 40)
23 ROP SETTING
IRIS LEV MOD Refer to the following section in the operating instructions.
“37 ROP SETTING”
M.PED CONT
LOCK SELECT
AUTO BUTTON
G/M PED VOL
FREE+LOCK
CAM SEL
DTL BUTTON
SKIN VOL
LCD BRIGHT
PANEL BRIGHT
B.GAMMA VOL
BUZZER
PERIOD
CYCLE
STD POSITION M.PED
STD POSITION VAR
STD POSITION ND
STD POSITION CC
IRIS PRIORITY
ROP DATA SAVE
ROP DATA LOAD
SD CARD FORMAT
INITIAL with NW
INITIAL
UPGRADE
IRIS CALIBRATION TOP
IRIS CALIBRATION BOTTOM
SYSTEM VERSION
SOFT VERSION
FPGA VERSION
24 CONNECT SETTING
CONNECT MODE CAM1
“CONNECT MODE CAM1” (see page 42)
CONNECT MODE CAM2 to
CAM99
“CONNECT MODE CAM2 to CAM99” (see page 42)
- 12 -
ROP Menu (when AK-UB300G is connected)
To Next Page
Loading...
