Panasonic AK-HRP1005G

Connecting the Unit to AK-UB300G Series Cameras
NOTE
The descriptions in this document assume that the system version of the unit is V4.40-00-0.00 or later. Make sure that the system
version of the AK-UB300G used in conjunction with the unit is V7.52-000-00.00 or later.
System block diagram
This is the configuration for connecting one AK-UB300G and one remote operation panel.
A
B
C
IRIS
E
ZOOM/FOCUS
D
F
(AK-UB300G)
A. Remote control lens
B. HD monitor (for HD main line)
C. HD monitor (for HD monitor)
D. External DC power supply
E. UHD/HD monitor (for UHD/HD main line)
F. AK-HRP1005G
Video output
For UHD mode
For UHD main line: Use the output from the <UHD/HD SDI OUT 1> to <UHD/HD SDI OUT 4> terminals.
For HD main line: Use the output from the <HD SDI OUT 1> terminal.
For HD monitor: Use the output from the <HD SDI OUT 2> terminal.
For UHD CROP mode/HD mode
For HD main line: Use the output from the <HD SDI OUT 1> terminal, or the output from the <UHD/HD SDI OUT
1>/<UHD/HD SDI OUT 2> terminal.
For HD monitor: Use the output from the <HD SDI OUT 2> terminal.
Remote operation panel
Connect AK-HRP1005G to the <I/F> terminal or the <LAN> terminal of the AK-UB300G.
- 3 -
Connecting the Unit to AK-UB300G Series Cameras