Panasonic BL-C10 - Page 52

Operating Instructions
52
Notes
• If your camera will only be accessed on your local network, use each
camera's local IP address and port number.
• If you intend to access your camera from the Internet, you must use each
cameras global IP address and respective port number.
4. Click [Save] when finished.
• New settings are saved.
• The Multi-Camera Setup page is displayed.
Setting Description
Display • Check the box to enable the camera.
IP Address
*1
or
Host Name
*2
• Set the IP address or the host name to enable the camera.
Port No. • Set the port number (1—65535).
Camera Name
*3
• This camera name is displayed only on the Multi-Camera
page.
*1
Set 4 digits (0—255) and 3 periods such as "192.168.0.253". But "0.0.0.0" and
"255.255.255.255" are not available.
*2
Enter ASCII characters for the host name (see page 102). But [Space], ["], ['],
[#], [&], [%], [=], [+], [?], [<] and [>] are not available.
Enter 1—255 characters.
*3
Enter ASCII characters (see page 102) or characters in each language (1—15
characters for a 1-byte character and 1—7 characters for a 2-byte character).
But [Space], ["], ['], [#], [&], [%], [=], [+], [?], [:], [<], and [>] are not available.