15
Detaching and Attaching the Stand
The stand is detachable.
• When detaching and attaching the stand, it is recommended that you place the monitor flat on the edge of a desk or table with a soft
cloth or similar material spread underneath.
• The stand is specifically designed for this monitor and cannot be used with other monitors. The stands supplied with the BT-LH1700W/
1710/1760 series cannot be used with this unit.
Detaching the stand
Stand screws
Unscrew the stand screws (three) using a Phillips screw-
driver.
• After detaching, store the stand and the stand screws for the
stand in a location easily accessible when required.
Attaching the stand
③
①
②
1. Align the holes in the stand with those in the monitor.
2. Use a Phillips screwdriver to secure the stand to the
monitor with the stand screws (three).
• Install the stand screws in the (① to ③) order shown in the
figure.
To Next Page
Loading...
