Panasonic ceCT-27D10 - Installation; Television Location; Optional Cable Connections; AC Power Supply Cord

Installation
Installation
Television
Location
This unit is
intended to be used
with an optional
stand or
entertainment center.
Consult
your dealer
for available options.
Avoid excessive
sunlight
or
bright lights, including
reflections.
Keep
away
from
excessive
heat
or
moisture. Inadequate
ventilation may cause
internal
component
failure.
Fluorescent lighting may reduce
remote control
transmitting
range.
Keep
away
from magnetic equipment,
including motors, fans and
external speakers.
Optional
Cable
Connections
Shielded
audio and
video cables should
be
used
between
components.
For
best
results:
Use 75-ohm
coaxial
shielded cables.
Use
appropriate
input and output
connectors, that match
your
component connectors.
Avoid long cables to
minimize
interference.
AC
Power
Supply
Cord
CAUTION: TO
PREVENT ELECTRIC SHOCK
MATCH WIDE BLADE OF PLUG
TO
WIDE SLOT
OF AC
OUTLET AND FULLY
INSERT
DO
NOT USE A PLUG
WITH A
RECEPTACLE
OR OTHER
OUTLET
UNLESS THE BLADE
CAN
BE
FULLY
INSERTED TO PREVENT
BLADE
EXPOSURE. FOR SOME
MODELS
THAT ARE
NON-POLARIZED, THE
USE OF
AN AC ADAPTOR
CONNECTOR
MAY
BE
NECESSARY.
Cable
/
Antenna
Connection
For proper reception,
either
a
cable or antenna
connection is
required.
Cable
Connection
incoming Cable from
Cable
Company
Connect the cable
supplied
by
your
local cable
connpany.
Note: A
cable
converter box may be
required for proper
reception.
^
Check with
your
local cable
compariy
for compatibility
requirements.
75
0hmVHF/UHF
^
on back of
TV
Antenna
Connections
For proper reception
of
VHF/UHF channels,
an external
antenna is
required.
For best reception an
outdoor
antenna is recommended.
Antenna Mode
must
be
set to TV.
incoming
Cable
from
^
Home
Antenna
Cable
Preset
Cable Mode
is preset at the
factory.
Antenna
users
must change to
Antenna Mode in the
Setup Menu.
Non-Polarized plug