92
Setup Utility
*4
The display destination in cases where Windows is not running is set here. If an external display is
not connected, all information will appear on the internal LCD even if [External Monitor] or
[Simultaneous] is selected.
After Windows starts up, the screen is displayed on the display destination set in the following menu.
[start] - [Control Panel] - [Other Control Panel Options] - [Intel(R) Extreme Graphics] - [Devices]
*1
Only for models with wireless LAN.
NOTE
[Advanced] menu cannot be changed when the Setup Utility is started up with the
User Password.
Parameters
(Underline indicates settings at the time of factory shipment.)
Advanced Menu
Serial Port A: [Auto]
Serial Port B: [Auto]
Modem: [Enable]
LAN: [Enable]
Boot up from LAN: [Enable]
Wireless LAN:
*1
[Enable]
Legacy USB Support: [Enable]
Serial Port A Disable
Enable
Auto
I/O IRQ
*2
3F8/IRQ4
2F8/IRQ3
3E8/IRQ7
2E8/IRQ5
To Next Page
Loading...
