Strap
Attaching the strap helpsyou stablyhold the computer.
Installing the hand strap
Before installing the hand strap, detach the tablet from the keyboard base. And then turn over the tablet.
C A U T I O N
n Place the computer on a soft cloth with the panel side down. In addition, make sure that there is no item under the tablet.
1. Pass the belt which has an adjuster (A) through the strap holes (B) located on the upper side of the back of the tablet.
2. Pass the belt through the adjuster and securely tighten it so it does not loosen.
3. Pass the belt which has the Velcro straps through the strap holes (C) located on the side of the back of the tablet.
4. Securely attach the bonded part of the belt so it does not loosen.
Insert the tip of belt into the cut hole of the hand strap.
To Next Page
Loading...
