Panasonic CF-20 series

Legacy USB Support Disabled
Enabled
Camera Configuration
Camera (Front)
Only for model with camera.
Disabled
Enabled
Camera (Rear)
Only for model with rear camera.
Disabled
Enabled
Boot Menu
Underlined items are the factory presets.
Boot Mode
If the startup from USB devicesis not possible, set [Compatible] and retry.
However, setting [Compatible] will require longer time to display the Windows
boot screen than setting [Normal].
Normal
Compatible
UEFI Priorities
The sub-menu appears when this item is selected.
Enter the sub-menu.
UEFI Priorities
Boot Option #1 - #7 Windows Boot Manager
Recovery Partition
Windows Recovery Environment
UEFI: PXE IP4 Intel(R) Ethernet Connection (4) I219-LM
[Tablet]
UEFI: PXE IP6 Intel(R) Ethernet Connection (4) I219-LM
[Tablet]
UEFI: PXE IP4 Realtek USB Ethernet Controller [Key-
board Base]
UEFI: PXE IP6 Realtek USB Ethernet Controller [Key-
board Base]
Disabled
UEFI Boot Device Control
Set whether to enable or disable the startup of each device.
UEFI Boot from Hard Disk Disabled
Enabled
UEFI Boot from LAN Disabled
Enabled
UEFI Boot from USB Disabled
Enabled
To change the boot order
[Boot Option] for [UEFI Boot Device Control] shows the boot device recognized by Firmware (BIOS).
Boot from a device or not can be selected at [UEFI Priorities], device by device.