Panasonic CQ-DVR592U

53
E
N
G
L
I
S
H
38
CQ-DVR592U
Anti-Theft System
52
Troubleshooting(continued)
CQ-DVR592U
E
N
G
L
I
S
H
37
❐ MP3
Folder/file name is not
displayed correctly.
File playing time is not
displayed correctly.
The disc does not conform to any of the file systems supported by this
unit.
➡ Insert a disc that conforms to the file systems supported by this
unit. For supported file systems, see “Notes on MP3”.
You turned off the ignition switch of the car during playback.
➡ Playing another file will return the file playing time to normal.
You played a VBR (Variable Bit Rate) format MP3 file.
➡ The file playing time of VBR (Variable Bit Rate) format MP3 file is
sometimes displayed incorrectly.
➡There may a problem with your writing software or CD recorder
(CD-R/RW drive). For details, refer to user manual of your writing
software.
❐ DVD/Video CD/CD (continued)
≥ It is not possible to switch if the disc does not have multiple audio
languages/subtitle languages/angles recorded on it.
➡ Refer to the guide provided with your disc.
≥ Some discs permit switching through a menu screen.
≥ Sometimes, switching angles is possible only with certain scenes.
Cannot switch the audio
language/subtitle
language/angle.
If audio or subtitles in that language are not recorded on the disc, the
audio or subtitles do not switch to that language. (Some discs permit
switching through a menu screen.
➡ Refer to the guide provided with your disc.
The audio/subtitle
language selected in the
initial settings is not
used.
➡ Check the setting for “Menu Language” in the user settings.
Messages in the menu
screen are not in the
desired language.
No playback.
The disc does not conform to any of the file systems supported by this
unit.
➡ Insert a disc that conforms to the file systems supported by this
unit. For supported file systems see “Notes on MP3”.
The MP3 file is missing the “.mp3” file name extension.
➡ Make sure to add the “.mp3” extension to each MP3 file name.
It takes too long for
playback to start.
The folders and files recorded on the disc are layerded too much.
➡ As checking of files takes longer in this case, do not record any
unnecessary folders or files other than MP3s on the disc.
Trouble Cause/Step
Trouble Cause/Step
❐ MP3 (continued)
Trouble Cause/Step
No sound from left, right,
front or rear speakers.
Left and right balance, or front and rear balance is off on one side.
➡ Adjust balance/fader setting as appropriate.
❐ Sound Setting
The right speaker wire is connected to the left speaker and the left speaker
wire to the right speaker.
➡ Connect the speaker wires to the correct ones.
Left and right sounds are
reversed in stereo
listening.
Dynamic range
compression does not
work. (“DRC” does not
light . )
Trouble Cause/Step
Cables are not correctly connected.
➡ Connect the cables correctly.
This function only works with Dolby Digital encoded material.
Poor recording quality,
sound skipping
➡ The recording quality differs depending on the encoding software
used, and on settings such as the bit rate. Set the bit rate within the
range specified in the specifications chart. (➡ page 75)
It is recommended to set the bit rate to “128 kbps or more” and “Fixed”.
High-speed writing was executed when MP3 data was recorded on the disc.
➡ Decrease writing speed as low as possible.
Files are not played in
the desired order.
Files or folders are not recorded in the desired playback order.
➡ Some writing software lets you specify the recording order by adding
a prefix in the range of 01–99, etc. to the file name. For details, refer
to the user manual of your writing software.
No subtitles appear.
Subtitles must be recorded on the disc, or they will not appear.
➡ Refer to the guide provided with your disc.
The picture becomes
distorted while fast
forwarding or reversing.
➡ A certain amount of distortion is normal.
It is difficult to hear
quiet sounds.
➡ Set the Dynamic range compression setting to “Minimum”.
➡ Adjust the output level setting at the menu of “Audio Output Level”.The sound volume level
is too low or too high.