– 41 –
MAC9512086C2
CS-A73KE
Servicing Information
Fig. 5
Screw
Fan motor
To install back the
Fan motor,
Please adjust the
connector location.
– Finally remove the fan motor by removing the
screw. (Fig. 5)
– REMINDER - To reinstall the fan motor, adjust
the connector of the fan motor as Figure 5.
• Cross Flow Fan Removal Procedure.
1. Remove the control board and the fan motor by
referring to the "Indoor Fan Motor Removal
Procedure".
2. Remove the evaporator screw (Fig. 6)
3. Press the particular piece to loosen the evaporator.
(Fig. 7)
4. Remove the bearing. (Fig. 7)
5. Push up the evaporator and take out the cross flow
fan. (Fig. 7)
Evaporator screw
Fig. 6
Push up
evaporator
Press the
particular
piece
Bearing
➞
Fig. 7
cross flow fan
Evaporator
Untitled-14 6/19/00, 11:19 AM41
To Next Page
Loading...
