104
8.
Pull out the main
electronic controller
halfway.
6.
Detach the CN-DISP
connector then remove
the indicator PCB complete.
9.
Detach connectors as labeled from the
electronic controller, then pull out the
electronic controller gently.
7.
Detach the Earth wire
screw, terminal wire (BL),
terminal wire (RED) and earth
wire screw (Green).
5.
Remove the screw to dismantle
the terminal board complete.
CN-FM
CN-STM1
CN-TH
AC303
Figure 3 Figure 4
18.1.3 To Remove Discharge Grille
Discharge Grille
11. Then pull the Discharge Grille
downward gently to dismantle it.
10. Pull out to remove the drain hose (behind the discharge grille)
from the Discharge Grille outlet.
Figure 5
To Next Page
Loading...
