Outdoor Unit
• To protect compressor from reverse
rotation when there is a instantaneous
power failure.
60 Secs. Forced Operation Control
• Once the compressor is activated, it
does not stop within the first 60 secs.
However, it stops immediately with
remote control stop signal.
Overload Protector
• 2-Stage OLP to protect the compressor.
Overload Protector will trip when
– Temperature of compressor increases
to 120C.
– High temperature or high current flows
to compressor.
(Refer circuit diagram for OLP
characteristic)
Compressor Reverse Rotation
Protection Control
Outdoor Fan Operation Control
•
There is a service port inside the outdoor
unit. The port can be connected to a
device which controls the outdoor fan
motor when the cooling operation mode
is used in cold winter.
4
CS-PV9CKE CU-PV9CKE / CS-PV12CKE CU-PV12CKE
To Next Page
Loading...
