105
18.1.1.3 To Remove Power Electronic Controller
8. Pull out the main
electronic controller
halfway.
the electonic controller. Then pull out
main controller gently.
7. Remove screw to remove
terminal board complete
and earth wire.
6. Detach the CN-DISP
connector then remove
the indicator complete.
5. Detach the Earth wire
screw.
9. Detach connectors as labeled from
CN-RMT
CN-FM
CN-STM1
CN-MSENS
CN-TH
CN-DISP
Figure 3 Figure 4
18.1.1.4 To Remove Discharge Grille
10. Pull out to remove the drain hose
from the discharge grille.
11. Then pull out the discharge grille
downward gently to dismantle it.
Figure 5
To Next Page
Loading...
