104
WARNING
18. Disassembly and Assembly Instructions
High Voltage is generated in the electrical parts area by the capacitor. Ensure that the capacitor has discharged sufficiently before proceeding with
repair work. Failure to heed this caution may result in electric shocks.
18.1 CS-RE9SKUA CS-RE12SKUA
18.1.1 Indoor Electronic Controllers, Cross Flow Fan and Indoor Fan Motor Removal
Procedures
18.1.1.1 To Remove Front Grille
3. Hold both sides of the front grille and
remove it by pulling up and toward
yourself gently.
1. Lift to open the horizontal vane
gently.
2. Remove 2 caps and 2 screws at the
bottom discharge vane.
Figure 1
18.1.1.2 To Remove Horizontal Vane
4. Remove the control
board cover by
releasing the hook.
Hook
Figure 2
To Next Page
Loading...
