Panasonic CS-RE18SKUA

54
13.5.3 Horizontal Airflow (CU-RE18SKUA CU-RE24SKUA)
 Automatic horizontal airflow direction can be set using remote control; the vane swings left and right within the
angles as stated below. For heating mode operation, the angle of the vane depends on the indoor heat
exchanger temperature as Figure 1 below.
Operation Mode Vane Angle (°)
Heating with heat exchanger temperature
A 68 ~ 112
B 90
Cooling and Soft Sry 68 ~ 112
Indoor Heat Exchanger
Temperature
109.4°F
104.0°F
A: swing
B: fix front
0°
To p V i ew
5
4
3
Figure 2
2
1
Figure 1
 Manual vertical airflow direction can be set using remote control; the angles of the vane are as stated below and
the positions of the vane are as figure below:
54321nrettaP
Airflow Direction
Patterns at Remote
Control
Vane Angle (° ) 90 68 78 102 112
13.6 Quiet Operation (Cooling Mode/Cooling Area of Dry Mode)
 Purpose
o To provide quiet cooling operation compare to normal operation.
 Control condition
o Quiet operation start condition
 When “Quiet” button at remote control is pressed.
Quiet LED illuminates.
o Quiet operation stop condition
 When one of the following conditions is satisfied, quiet operation stops:
 POWERFUL/QUIET button is pressed.
 Stop by OFF/ON button.
 OFF Timer activates.
 POWERFUL/QUIET button is pressed again.
 When quiet operation is stopped, operation is shifted to normal operation with previous setting.
 When fan speed is changed, quiet operation is shifted to quiet operation of the new fan speed.
 When operation mode is changed, quiet operation is shifted to quiet operation of the new mode.
 During quiet operation, if ON timer activates, quiet operation maintains.
 After off, when on back, quiet operation is not memorised.
 Control contents
o Auto fan speed is change from normal setting to quiet setting of respective fan speed. This is to reduce
sound of Hi, Me, Lo for 3dB.
o Manual fan speed for quiet operation is -1 step from setting fan speed.