Panasonic CS-RE18SKUA

60
14.2.5 Dew Prevention Control 1
 To prevent dew formation at indoor unit discharge area.
 This control will be activated if:
o Outdoor air temperature and Indoor pipe temperature judgment by microcontroller is fulfilled.
o When Cooling or Dry mode is operated more than 20 minutes or more.
 This control stopped if:
o Compressor stopped.
o Remote control setting changed (fan speed / temperature).
o Outdoor air temperature and indoor intake temperature changed.
 Fan speed, angle of louver (vertical airflow angle) will be adjusted accordingly in this control.
1. Fan speed will be increased slowly when control is activated until predetermine value.
 Compressor frequency will be regulated accordingly.
14.2.6 Protection Control For Heating Operation
14.2.6.1 Intake Air Temperature Control
Compressor will operate at limited freq., if indoor intake air temperature is 86°F or above.
14.2.6.2 Outdoor Air Temperature Control
 The maximum current value is regulated when the outdoor air temperature rise above 57.2°F in order to avoid
compressor overloading.
57.2°F
52.6°F
Free withing maximum limit
Current Regulated
O
utdoor Air Temperature
 The compressor will be stopped at outdoor air temperature ≤ -4°F. The unit still operate within the temperature
range.
-0.4°F
-4°F
Compressor OFF
Compressor ON
O
utdoor Air Temperature