120
o Press TEMP increment or decrement button to choose No. 12.
o Press Timer increment or decrement button to select desired temperature low limit of set temperature for
AUTO mode.
o Press Timer Set button to confirm low limit selection.
o Press TEMP increment or decrement button to choose No. 13.
o Press Timer decrement or increment button to select desired temperature high limit of set temperature for
AUTO mode.
o Press Timer Set button to confirm high limit selection.
o LCD returns to original display if remote control does not operate for 30 seconds or press Timer Cancel
button.
Memorize new
Low3 range
Normal display mode
Press SW to enter customer zone &
Press SW to comfirm selection
Use SW or SW to change Low3 range
SET
i) Display latest set temp (Low3).
ii) After reset, Low3 = 16°C (by default)
Range = 16°C ~ [High3]
No code transmission
SET
Press
SW’s to choose function 12
Memorize new
High3
range
Normal display mode
Press SW to enter customer zone &
Press SW to comfirm selection
Use SW or SW to change High3 range
SET
i) Display latest set temp (High3).
ii) After reset, High3 = 30°C (by default)
Range = [Low3] ~ 30°C
No code transmission
SET
Press
SW’s to choose function 13
To Next Page
Loading...
