Panasonic CS-TZ71ZKEW

72
12.4.4 Connect the Cable to the Indoor Unit
 The power supply cord, indoor and outdoor unit connection cable can be connected without removing the front
grille.
1 Install the indoor unit on the installing holder that mounted on the wall.
2 Open the front panel and grille door by loosening the screw.
3 Cable connection to the power supply through Isolating Devices (Disconnecting means).
o Connect the approved polychloroprene sheathed Power supply cord 3 x 2.5 mm
2
(2.25 ~ 2.5HP), type
designation 60245 IEC 57 or heavier cord to the terminal board, and connect the other end of the cable
to Isolating Devices (Disconnecting means).
o Do not use joint power supply cord. Replace the wire if the existing wire (from concealed wiring, or
otherwise) is too short.
o In unavoidable case, joining of power supply cord between isolating devices and terminal board of air
conditioner shall be done socket and plug rated 16 A (2.25HP) or 20 A (2.5HP). Wiring work to both
socket and plug must follow to national wiring standard.
4 Bind all the Power supply cord lead wire with tape and route the power supply cord via the left side
escapement.
5 Connection cable between indoor unit and outdoor unit shall be approved polychloroprene sheathed 4 x
2.5 mm
2
(2.25 ~ 2.5HP) flexible cord, type designation 60245 IEC 57 or heavier cord.
6 Bind all the indoor and outdoor Connection cable with tape and route the connection cable via the right side
escapement.
7 Remove the tapes and connect the power supply cord and connection cable between indoor unit and outdoor
unit according to the diagram below.
Change the drain hose position
Rear view for left piping installation
Drain cap
Drain hose
Drain hose
Connection cable
Adjust the piping slightly downwards.
Sleeve for piping hole
Drain hose
Piping
Connection cable
More than 1150 mm
•
How to pull the piping and drain hose out,
in case of the embedded piping.
PVC tube for
drain hose
Indoor unit
66 mm
Piping
Cable
Apply putty or
caulking material
to seal the wall
opening.
Connection cable
Piping
More than
470 mm
More than
1150 mm
PVC tube (VP-65) for piping
and connection cable
More than 700 mm
Drain hose
from main unit
PVC tube for drain hose (VP-30)
PVC tube for
drain hose (VP-20)
•
In case of left piping how to insert the connection
cable and drain hose.
Cable
45°
Drain hose
Piping
(For the right piping, follow the same procedure)
WARNING
This
equipment
must be
properly
earthed.
Recommended
length (mm)
refer table below
Terminals on the outdoor unit S1 2 3 123
Colour of wires (connection cable)
Terminals on the indoor unit L 1 N S1 2 3 OR L 1 N S1 2 3
(Power supply cord)
* Connection for multi
inverter model (Outdoor
power supply)
Terminals on the isolating devices
(Disconnecting means)
(L) (N)
Tape
Power
supply cord
Connection cable
Tape