39
10.2.8 Auto switch operation
The following operations can be performed by
pressing the “AUTO” switch.
1 AUTO OPERATION MODE
The Auto operation will be activated
immediately once the Auto Switch is pressed.
2 TEST RUN OPERATION (FOR PUMP
DOWN/SERVICING PURPOSE)
The Test Run operation will be activated if the
Auto Switch is pressed continuously for more
than 5 sec. to below 8 sec. A “pep” sound will
occur at the fifth sec., in order to identify the
starting of Test Run operation.
10.2.9 Changing the remote control transmission code
1 Press AUTO switch on indoor unit
continuously for 11 seconds (Buzzer sound =
pep pep pep)
2 After 11 seconds, release AUTO switch, then
press remote control TIMER “▼” button
continuously for 5 seconds. Reset code will be
transmitted. After transmitted reset code,
release TIMER “▼” button.
3 Press remote control “OFF/ON” button. The
new remote control number will be accepted
and memorized, after which the new remote
control number can be used.
Remote control number change in Remote Controller
1 Remove battery from the battery compartment
in the Remote Controller.
2 At left side of battery compartment, there is a
small opening at the centre in which a Jumper
(J_A) can be seen. Also in remote control
PCB shown below, Jumper (J_B) can be
seen.
J_A J_B
Remote control
number
Short Open A(Default)
Open Open B
Short Short C
Open Short D
To Next Page
Loading...
