134
SettingBacking up/restoring data
Outputting settings as a CSV le
Export (output) the settings for this unit as a CSV le.
The settings that are exported are as follows:
y Indoor unit settings y Outdoor unit settings y Distribution group settings
y Schedule group settings y Pulse meter settings y Communication adaptor settings
y Area settings y Schedule y Events
4
Touch [Trgt].
z The “Output target” dialogue is displayed.
4
5
Touch setting name to be exported.
z The settings are registered and the “Output target”
dialogue closes.
5
Continued on next page
1
Open the storage door and connect
a USB memory device to the USB
terminal.
z This step is not necessary if you are backing up over a
network.
2
Touch [Backup/CSV Output] in
“Settings”.
z The “Backup/CSV Output” screen is displayed.
2
3
Touch [CSV Output].
z The “CSV Output” screen is displayed.
3
135
SettingBacking up/restoring data
6
Touch [Export].
z Exporting starts. The message “Exporting of XXX CSV le
was successful.” is displayed when the export nishes.
z To export other settings, repeat steps 4 to 6.
z To cancel the export, touch [Cancel].
6
7
Touch when you want to
disconnect the USB memory device.
z Remove your USB memory device after the message
“USB memory can now be safely removed” is displayed.
z Close the storage door after removing the USB memory
device.
Note
y The time required for export depends on the volume of data.
Outputting settings as a CSV le
To Next Page
Loading...
