STEP 3 Set up to match your television and remote control
buttons
SETUF
bu_ons
A,T,<I,b-
ENTER
RETURN
You can configure the remote control TV operation buttons to turn
the television on/off, change the television input mode, select the
television channel and change the television volume.
Point the remote control at the television
While pressing [_ POWER TV], enter the
code with the numbered buttons.
e.g., 01: [O] ,,* [1]
Manufacturer and Code No.
Panasonic
National 01,02
QUASAR
FISHER 10
GE 05
GOLDSTAR 15, 16, 17
HITACHI 12
JVC 11
LG 15, 16, 17
MAGNAVOX 03
MITSUBISHI 13
PHILIPS (RC-5) 03
RCA 05
SAMSUNG 14, 18, 19
SANYO 10
SHARP 06, 07
SONY 08
SYLVANIA 03
THOMSON 05
TOSHIBA 09
ZENITH 04
Test by turning on the television and changing channels. Repeat
the procedure until you find the code that allows correct operation.
*If your television brand is not listed or if the code listed for your
television does not allow control of your television, this remote
control is not compatible with your television.
You do not have to change the setting when connected to a 4:3
standard aspect television that is not compatible with progressive
output (m page 46).
I Press [SETUP].
2 Press [&, •1 to select "TV Screen"
and press [1_].
3 Press [&, •] to select "TV Type" and
press [ENTER].
4
* Aspect 4:3/Aspect 16:9:
4:3 standard aspect 16:9 widescreen
television television
*480P/480h
Select "480P" if the television is compatible with
progressive output.
Press [&, •] to select the item and
press [ENTER].
To exit the screen
Press [SETUP].
To return to the previous screen
Press [RETURN].
To Next Page
Loading...
