14
Press the MODE key 5 times
or keep it pressed for 2 sec.
or more.
9Press the [MODE key] 5 times or keep it pressed for 2 sec.
or more, the amplifier will return to ‘RUN mode’ (normal
sensing operation).
6The setting for ‘lower limit value 1_SL’ will be displayed.
7The setting for ‘upper limit value 2_SL’ will be displayed.
5The display will indicate whether the upper and lower
threshold value limits have been correctly set or not.
• If ‘ ’ is blinking…the upper and lower limits have
been set correctly.
• If ‘ ’ is blinking…the upper and lower limits have
not been set correctly.
* The factory setting for shift value is ‘100’.
To set the shift value, refer to the section entitled
‘10-2. Output 1 Sensing Mode Settings’ from ‘PRO6 Mode’
on p.56.
8The output 1 will again be displayed, indicating that
configuration is now complete.
Lower limit value 1_SL
Upper limit value 2_SL
Upper and lower limits have
not been correctly set.
Stable sensing
To Next Page
Loading...
