3-2. Factory Settings
Factory settings for the FX-301(P)(-HS)/305(P) are indicated below:
If the unit is reset using the ‘9-4 Setting Reset Function’ from ‘PRO5 Mode’ on p.53, the resulting settings will be
those indicated below:
Output 1:
,
Output 2:
Model No.
Item
Response time
Timer period
Hysteresis
Stability
Shift amount during limit teaching
Light emitting amount selection function
Display
Display turning
ECO mode
Selection for transmission change to permit / not to permit
Backup
Code
Adjust lock
Interference prevention switching function [FX-305(P) only]
Sensing mode [FX-305(P) only] (Note)
Settings
Standard (standard)
10 ms
H-02 (standard)
S-02 (standard)
15 %
Level 4 (MAX)
Incident light intensity display
OFF
OFF
OFF
ON
0004
ON
Settings
40
L-ON
Without timer
Digital display
FX-301(P)FX-301(P)-HS
Digital displaySettings
80
L-ON
Without timer
Digital display
Digital display
FX-301(P)
Error description
FX-305(P)
Measures
Turn off the power, then check the
load.
Confirm that all amplifiers are
properly connected to each other.
The load has short-circuited and excess
current is flowing.
: Output 1, : Output 2
FX-301(P)FX-301(P)-HS
FX-305(P)
FX-305(P)
Settings
Standard F (standard 2)
10 ms
H-02 (standard)
15 %
Level 4 (MAX)
Incident light intensity display
OFF
OFF
OFF
ON
J004
ON
IP-1
Normal mode
Settings
Output 1: 80, Output 2: 120
L-ON
Without timer
Digital display
Settings
H-SP (ultra high-speed)
10 ms
H-02 (standard)
S-02
(standard)
15 %
Level 2
Incident light intensity display
OFF
OFF
ON
004
ON
Digital display
NAVI mode
PRO mode
3-3. Error Display Indicator Readings
In case of errors, attempt the following measures:
Note: In window comparator mode, the factory settings for teaching method is ‘2-level teaching’.
Model No.
Item
Threshold value
Light-receiving operation
Timer operation
Communication error has occurred at
time of connection.
In case of using functions of PRO4
mode
()
(ON when light is received) (ON when light is received)(ON when light is received)
4
To Next Page
Loading...
