32
S-01
margin
width:
5 %
S-02
margin
width:
10 %
S-03
margin
width:
15 %
The digital display will quickly
blink 3 times to confirm the setting.
5-6. Stability Function [FX-301(P)(-HS) only]
This function permits selection among three different stability indicator response levels
(margin width: 5 % / 10 % / 15 % ), for changes in the range of incident light.
1 Press the [MODE key] 5 times to select ‘PRO mode’.
2 Turn the [Jog switch] once toward the ‘’ direction,
to select ‘PRO1 mode’.
3 Press the [Jog switch] to enter the ‘response time change’
state.
4 Turn the [Jog switch] 3 times toward the ‘’ direction,
to enter the ‘stability setting’ state.
5 If the [Jog switch] is pressed, the current setting for
‘stability level’ will be displayed.
* The factory setting is ‘S-02 (margin width:
10 %)’.
6 If the [Jog switch] is turned, the digital display will blink.
Select the desired ‘stability level’.
7 If the [Jog switch] is pressed, the digital display will quickly
blink 3 times, confirming ‘stability level’ setting.
8 Press the [MODE key] 3 times or keep it pressed for 2 sec.
or more, the amplifier will return to ‘RUN mode’ (normal
sensing operation).
Press the MODE
key 5 times.
Turn the Jog switch
once toward
the ‘
’ direction.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Turn the Jog switch to select
the desired stability level.
Press the MODE key
3 times or keep it pressed
for 2 sec. or more.
Turn the Jog switch
3 times toward
the ‘
’ direction .
To Next Page
Loading...
