The digital display will blink
twice to confirm the setting.
Press the MODE key
3 times or keep it pressed
for 2 sec. or more.
7-2. Data Bank Load Setting Function
This function allows configuration settings information from the data bank to be selected and then loaded.
This feature allows settings to be changed quickly at times of reconfiguration, etc.
1 Press the [MODE key] 5 times to select ‘PRO mode’.
2 Turn the [Jog switch] 3 times toward the ‘’ direction,
to select ‘PRO3 mode’.
3 Press the [Jog switch] to enter the ‘data bank load setting’
state.
4 If the [Jog switch] is pressed, the digital display will blink.
5 If the [Jog switch] is turned, the ‘channel’ will be changed.
Select the desired ‘channel’ for loading.
6 If the [Jog switch] is pressed, the letters ‘ ’ will blink.
8 Press the [MODE key] 3 times or keep it pressed for 2 sec.
or more, the amplifier will return to ‘RUN mode’ (normal
sensing operation).
7If the [Jog switch] is pressed while ‘ ’ is blinking, the
configuration settings will be loaded from the selected
‘channel’. The digital display will blink twice, confirming the
new setting.
Turn the Jog switch to select the
desired channel for loading.
Press the MODE
key 5 times.
Press the
Jog switch.
Press the
Jog switch.
Turn the Jog switch 3 times
toward the ‘’ direction.
Press the
Jog switch.
Press the
Jog switch.
Channel 1 Channel 2 Channel 3
41
To Next Page
Loading...
