36
:
Digital Display Inversion Function
This function can be used to invert the display orientation, according to the
direction of amplifier installation.
* The factory setting is ‘Turn OFF’.
Refer to p.38 for setting procedure
When set to ‘Turn OFF’ When set to ‘Turn ON’
:
ECO Mode Setting Function
This function turns off the digital display to reduce current consumption.
If no operations are performed for 20 sec., the letters ‘ ’ will blink and then the digital
display will turn off.
If the [MODE key] or the [Jog switch] are operated, the digital display will light up again.
*
The factory setting is ‘ECO OFF’.
Refer to p.39 for setting procedure
When set to ‘ECO OFF’ When set to ‘ECO ON’
When ECO mode is OFF:
40 mA or less (at 24 V supply voltage)
When ECO mode is ON:
25 mA or less (at 24 V supply voltage)
Current Consumption
To Next Page
Loading...
