Press the MODE key
3 times or keep it
pressed for 2 sec. or more.
Press the
Jog switch.
Press the
Jog switch.
The current shift amount
Press the MODE key
3 times or keep it
pressed for 2 sec. or more.
1-level
teaching
Window comparator mode
2-level
teaching
3-level
teaching
Turn the Jog switch to select
the desired teaching method.
Turn the Jog switch to select
the desired display method.
Turn the Jog switch to select
the desired shift amount.
Press the
Jog switch.
Incident light
intensity display
Percentage
display
The digital display will blink quickly
3 times to confirm the selection.
The digital display will blink quickly
3 times to confirm the selection.
7 If the [Jog switch] is turned, the digital display will blink.
Select the desired ‘teaching method’.
* The factory setting is ‘1-level teaching’.
,
8
If selecting 1-level teaching
in window comparator mode…
If the [Jog switch] is pressed,
the unit will enter the ‘display
method’ setting state. Turn the
[Jog switch] to select the
desired display method.
* The factory setting is ‘incident
light intensity display’.
If the [Jog switch] is pressed,
the unit will enter the ‘shift
amount’ selection state. Turn
the [Jog switch] to select the
desired shift amount.
* The factory setting for shift
amount is ‘100’.
Refer to p.13l for teaching
method.
If the [Jog switch] is pressed,
the digital display will blink
quickly 3 times to confirm the
selection.
Refer to p.15l / p.17l for
teaching method.
If selecting 2-level or 3-level
teaching in window
comparator mode
…
57
To Next Page
Loading...
