40
VQT3C18
The images from this unit do not appear on the
television.
Picture is distorted.
¾ Make sure that the television is connected to HDMI AV OUT
terminal on this unit. (> 25)
¾ Make sure that the television’s input setting (e.g., VIDEO 1) is
correct.
¾ When “24p Output” is set to “On”, HDMI authentication takes
place where 24p images switch to other images, and a black
screen is displayed. (> 32)
¾ When “24p Output” is set to “On”, jittering may occur while
playing DVD-Video other than 24p images. In this case, turn
“24p Output” to “Off”. (> 32)
¾ An incorrect resolution is selected in “
HDMI Video Format
”,
when the television is connected to HDMI AV OUT terminal.
Set the item again.
¾ Picture may not be seen when more than 4 devices are
connected with HDMI cables. Reduce the number of
connected devices.
¾ The unit and television are using different video systems.
Change the setting to match the equipment you are
connecting with. (> 33, “TV System” in the “TV Aspect /
HDMI Function Settings”)
¾ The system used on the disc doesn't match your television.
jPAL discs cannot be correctly viewed on an NTSC
television.
Video is not output in high definition.
¾ Confirm that the “HDMI Video Format” in the Setup menu is
set properly. (> 32)
The 4:3 aspect ratio picture expands left and right.
Screen size is wrong.
¾ Use the television to change the aspect. Refer to your
television’s operating instructions.
¾ When using an HDMI cable, change “TV Aspect” type to “4:3
Pan & Scan”. (> 32)
No sound from other speakers.
¾ Check all connections and settings. (> 25)
Cannot hear the desired audio type.
¾ Audio may not be heard when more than 4 devices are
connected with HDMI cables. Reduce the number of
connected devices.
Cannot switch audio.
¾ When connecting an amplifier/receiver using an HDMI cable,
you cannot switch the audio if “Dolby D/Dolby D +/Dolby
TrueHD” or “DTS” is set to “Bitstream”. Set “Dolby D/Dolby D
+/Dolby TrueHD” or “DTS” to “PCM”. (> 31)
Music on an SD card cannot be played.
¾ Data that can be played from an SD card are AVCHD,
MPEG2 and JPEG data. (> 7)
The contents of the card cannot be read.
¾ The card is not compatible or the contents on the card may
be damaged. (> 7)
¾ Turn off and then turn on the unit again.
Connection
Card
DMPB200EB-VQT3C18_eng.book 40 ページ ２０１１年１月２４日 月曜日 午後８時３２分
To Next Page
Loading...
Need help?
General
