ROT9378
Messages
The
following
messages
or
service
numbers
appear
on
the
television
or
unit's
display
when
something
unusual
is
detected
during
startup
and
use.
On the
television
Page
Authorization
Error
-
1m:
You
are trying
to
play the DivX VOD content that was purchased with a
26
This
unit
is
not
authorized
different registration code.
You
cannot play the content
on
this unit.
to
play
this
title.
Cannot
play.
-You
inserted
an
incompatible disc (Discs recorded
in
PAL
video, etc.).
6,
7
Cannot
display
on
this
unit.
-You
tried
to
playa
non-compatible image.
7,38
-Confirm
"SO"
on
the unit's display
is
not blinking and re-insert the card.
-
No
disc
is
inserted.
-The
disc may
be
upside down.
-
Rental Expired.
-
1m:
The DivX VOD content has zero remaining plays.
You
cannot play
it.
26
o This
operation
is
not
-Some
operations are unsupported
by
the unit. For example;
20
available.
-1m:
During
playback,
reverse
slow-motion
or
reverse
frame-by-frame
is
not
possible.
o This
operation
is - Depending
on
the disc,
you
may not
be
able
to
perform search or skip when film
20
prohibited
by
this
disc.
previews
and
warning screens are being played back.
Cannot
connect.
-When
a hub
is
used but its Link lamp does not light
up,
check the cable
16
Please
check
the
connection,
LAN
terminal connection, cable itself
(a
cross over cable may
be
connection
of
the LAN
used by mistake), etc.
cable.
IP
address
is
not
set.
-The
"IP Address"
in
"IP AddresslDNS Settings"
is
"---. ---. ---.
___
".
Set the "IP
17
Address", "Subnet Mask",
and
"Default Gateway". (Select the automatic address
acquisition if necessary.)
Cannot
obtain IP address
-If
you use a hub, then check the connection between the hub and the router.
16
using
DHCP.
-Use
the UPLINK port of the hub
to
connect
to
a router.
Please
check
the
-Check
whether or not the hub's Link lamp lights
up.
If it does not light
up,
then
connection
or
router
check the cable connection, LAN terminal connection, cable itself
(a
cross over
settings.
cable may
be
used
by
mistake), etc.
-If
the above conditions are
OK,
then the router may not operate
in
DHCP mode. 16
Check the router settings and operation.
You
may reset the router to restore it to
normal.
This IP
address
is already in
-This
unit's
IP
address
is
used by another device. Check the
IP
addresses of this
-
use.
unit, personal computers, and routers, etc. If necessary, reconfigure them
to
Please
check
the IP address
avoid
IP
addresses from being duplicated.
setting.
Unable
to
perform
-Turn
the unit off. Remove the power cord and reconnect it and try again. If the
-
Connection
Test.
same symptom persists, then consult your dealer.
Please
try
again.
IP
address
not
set
correctly.
Connection
Test was
-If
you use a hub, then check the connection between the hub and the router. 16
unsuccessful.
No reply
-Use
the UPLINK port of the hub
to
connect
to
a router.
from
host.
-If
the hub's Link lamp does not light
up,
then check the cable connection, LAN
Please
check
the
terminal connection, cable itself
(a
cross over cable may have been used
by
connection
or
router
mistake), etc.
settings.
-Check
the "IP Address", "Subnet Mask", and "Default Gateway"
in
the "IP 17
Address/DNS Settings".
-If
the MAC address information
is
required, then press [SETUP] to display the
17,
35
"Network" menu.
Network
connection
-When
you set "SO-Live Internet Access" to "Allow (Limited)" and play SO-Live
32
refused.
contents which do not have a content owner certificate, the Internet access of the
Please
confirm
Setup
content is not allowed. If
you
allow the content to connect to Internet, set "SO-Live
"SO-Live
Internet
Access."
Internet Access"
to
"Allow (ALL)".
Unable
to
check
for
latest
-The
firmware download server
is
currently unavailable. Please try again later.
-
firmware
version.
Please
try
again later.
High
Clarity
Sound
is
-"High
Clarity Sound"
in
setup menu
is
set
to
"Enable", and "High Clarity Sound"
in
31,33
effective.
on-screen menu
is
set
to
"On".
Analog
video
output
is
turned
off
when
playback
starts.
To Next Page
Loading...
