Item FL display Key operation
Mode name Description (Remote controller key)
Tray OPEN/
CLOSE Test
The RAM drive tray is opened
and closed repeatedly.
“*” is number of open/
close cycle times.
Press [9] [1] in service
mode
*When releasing this
mode, press the [POWER]
button on Front Panel
more than 10 seconds.
Error code
initialization
Initialization of the last error
code held by timer (Write in F00)
Press [9] [8] in service
mode.
Initialize Service Last Drive Error, Error history
and Error Codes stored on the
unit are initialized to factory
setting.
Press [9] [9] in service
mode.
Finishing service
mode
Release Service Mode. Display in STOP (E-E)
mode.
Press power button on
the front panel in service
mode.
12. (VHS) Self-Diagnosis and Special Mode Setting
12.1. (VHS) Self-Diagnosis Functions
This model has a self-diagnosis and display function. If the VHS section detects trouble during installation or during use, one of the
following Error Codes will automatically appear in the display on VHS side. Error Codes are displayed in the formof a single English letter
followed by two numbers, as for example "H01".
Note:
1. The indication "U" is displayed on the FIP while power remains on.
2. The indication "H" or "F" is displayed on the FIP, and the power is automatically turned off. When
56
To Next Page
Loading...
