Getting started
VQT4G61
11
1 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
2 Recording indicator
• The indicator will light up while recording.
• The indicator will blink while recording is
paused and before recording starts.
3 CALL LED
• The LED will light up when this unit receives
incoming call etc. of the video
communication. (> 61)
4 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
5 Start PAUSE LIVE TV (> 24)
6 USB port
7 SD card slot
• When removing the SD card, press on the
centre of the card and pull it straight out.
8 Channel select (> 22)
9 Start recording (> 26)
: Stop
; Start play
< Display
1 SD card slot indicator
2 Copying indicator
3 Drive (HDD or SD) indicator
4 Remote control signal indicator
5 Main display section indicator
- Current time
- Playback counter
- Various messages (> 83)
6 Playback indicator
7 USB port indicator
8 Timer recording indicator
• This indicator lights up when the timer
recording standby is activated.
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
Main unit
Pull to flip down
the front panel.
SD card
USB memory
PLAY
COPY
SD USB
HDDSD
12
34
5678
DMRHW220GL_eng.book 11 ページ ２０１２年４月２７日 金曜日 午後２時１２分
To Next Page
Loading...
