Getting started
SQT0815
16
Control reference guide
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right
way up.
Main unit
1 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
2 Open/close disc tray
3 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
4 Disc tray
5 USB port
6 SD card slot
• When removing the SD card, press on the
centre of the card and pull it straight out.
Pull to flip down
the front panel.
Display
Display
1 Drive (HDD, BD or SD) indicator
2 Disc indicator
3 Copying indicator
4 USB port indicator
5 SD card slot indicator
6 Remote control signal indicator
7 Timer recording indicator
This indicator lights up when the timer
recording standby is activated.
8 Main display section indicator
- Current time
- Playback counter
- Various messages (> 95), etc.
9 Playback indicator
10 Recording indicator
• The indicator will light up while recording.
• The indicator will blink while recording is
paused and before recording starts.
PLAY
COPY
SDUSB
HDD
SD
BD
12 5 6743
8910
DMR-PWT550GLGZ_eng.book 16 ページ ２０１５年２月２日 月曜日 午後７時２６分
To Next Page
Loading...
