Panasonic DMR-PWT550 - Sound

Troubleshooting
SQT0815
91
The images do not appear on the TV.
The picture is distorted during play, or video
is not played correctly.
• Check the connections. (> 17)
• Check the settings of the connected TV, etc.
• An incorrect resolution is selected in “HDMI
Video Format”. Reset the setting as follows:
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• “00 RET” is displayed on the front panel
display.
2 Repeatedly press [1] (right) until “04 PRG”
is displayed on the front panel display.
3 Press and hold [OK] for at least 3 seconds.
Set the item again. (> 71, 78)
• When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD
®
audio are not output
properly, select “Yes” in “Default Settings”
and make proper settings. (> 71, 83)
• The unit’s TV System is different from that of the
disc. Change the TV System. (> 78, TV
System)
• Picture may not be seen when more than
4 devices are connected with HDMI cables.
Reduce the number of connected devices.
• The picture may be distorted or a black screen
may appear between scenes recorded with
different aspect ratios.
• Set “Deep Colour Output” (> 71, 79) or
“Contents Type Flag” (> 71, 79) to “Off”.
3D video is not output correctly.
• 3D video may be output correctly by changing
the following settings:
- “3D Type” of “3D Settings” (> 71, 78)
- “Signal Format” (> 46, 3D settings during
playback)
• Check the settings of the connected TV.
• When a non-3D compatible amplifier/receiver is
connected between this unit and a TV, 3D video
is not output. (> 18)
• When the amplifier/receiver which is connected
between this unit and a TV is off, 3D video is not
output. (> 18)
• 3D discs may not be played back correctly due
to the settings of the TV.
• When “HDMI Audio Output” is set to “Off”, 3D
video may not be output correctly. (> 79)
No sound.
Distorted sound.
• Check the connections. (> 17)
• Check the settings of the connected TV, etc.
• Press [AUDIO] to select the audio. (> 28, 45)
• To output audio from a device connected with an
HDMI cable, set “HDMI Audio Output” to “On”.
(> 71, 79)
Cannot change audio channel.
• You cannot change the audio channel if “Digital
Audio Output” is set to “Bitstream”. (> 77)
The same video is displayed in each left and
right half of the screen.
• This is a 3D programme of the Side-by-Side
type.
Change the setting as follows if connecting with
a 3D compatible TV:
1 Press [OPTION].
2 Select “Playback Settings” in “Playback
Menu”, then press [OK].
3 Select “3D Settings”, then press [OK].
4 Select “Side by side” in “Signal Format”, then
press [OK].
Sound
DMR-PWT550GLGZ_eng.book 91 ページ ２０１５年２月２日 月曜日 午後７時２６分