Setup
TQBS0149
90
[DVB-C] RF OUT ( CATV Signal )
[DVB-T ] [DV B -T2] RF OUT ( Aerial Signal )
Set whether to output the broadcasting signal
from RF OUT or not while in standby mode
(When “Quick Start” is not activated).
• If “On” is selected, the broadcasting signal
is output from this unit.
Networked Standby
This unit can be turned on using a wake-up
message sent from the network device in the
home network. (Available only when “Quick
Start” is set to “Off”.)
•On:
- Power consumption increases when this
unit is in standby mode. (> 99)
- This unit can be used as a DLNA Server
when this unit is in standby mode. (This is
possible if you have ever connected your
client Panasonic recorder to the network
using this unit as a server.)
•Off:
- Power consumed when this unit is in
standby mode becomes smaller than that
consumed when “On” is selected. (> 99)
- When this unit is in standby mode, it
cannot be used as a DLNA Server.
• When you change the “On”/“Off” setting of
this function, the “On”/“Off” setting of “Home
Network function” also changes.
• If “Quick Start” and “Home Network function”
are set to “On”, even when this unit is turned
off, it can be used as a DLNA Server.
• This function may not work correctly depending on
network environment.
Remote Control
Change the remote control code on the main unit
and the remote control if you place other
Panasonic products close together.
• Use “Set Code 1”, the factory set code, under
normal circumstances.
1 Select the code, then press [OK].
2 While pressing [OK], press and hold the
number button ([1] to [6]) for more than
5 seconds.
3 Press and hold [OK] for more than 5 seconds.
4 Press [OK].
Clock
If the time is not set correctly, use the settings
listed in the method below.
• Automatic
This unit usually obtains time and date
information from digital broadcasts.
• Time Zone
When the time is not correct, set “Time Zone”.
(GMT ` 6 to r 6)
• Manual Setting
1 Select “Off” of “Automatic”, then press [OK].
2 Select the item you want to change.
3 Change the setting.
4 Press [OK] when you have finished the
settings.
• When the clock is set manually, you cannot perform
playing/recording/PAUSE LIVE TV/REWIND LIVE TV of the
programmes that are copy protected (Retention limit). (
>
10)
DMR-UBC86EN_eng.book 90 ページ ２０１７年８月８日 火曜日 午前１１時１２分
To Next Page
Loading...
