Configuring the Printer Driver Settings
35
Windows 98/Me
Printer Section
7. Timeout settings - Transmission retry
Specify the amount of time (in seconds) allowed to elapse before the printer is ready for printing. If the
printer is not ready for printing within this duration, an error message will be displayed.
Increase this value if a timeout error occurs when printing a large document.
8. button
Specify the method of sending (spool) documents from the program to the printer.
• Spool Data Format
Select spool data type (RAW format). Specifying RAW format results in a longer time elapsing before an
application becomes operational after printing from it.
• Enable bidirectional support
Be sure to check the check box for "Enable bidirectional support" when installing the status monitor.
Otherwise, status information reception may not function properly.
9. button
Modifies printer port settings.
Spool Settings...
Port Settings...
To Next Page
Loading...
