Panasonic DP-4530 - Page 792

792
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
11.3.3.1.3. PCBs
Fig. 3-070
(8) Remove the Stack Delivery Roller (lower) [15]
and 2 Delivery Belts [16].
Fig. 3-071
Caution:
Be sure to mount them so that the Edges [17] of
the Claws of the Delivery Belts are flush.
Fig. 3-072
3-1. Removing the Finisher Controller PCB
(1) Remove the Rear Cover. (See 1-3.)
(2) Disconnect 17 Connectors [1], and remove 1
Screw [2].
(3) Free the PCB Retainer [3], and detach the
Finisher Controller PCB [4].
Fig. 3-073
3-2. Removing the Slide Home Position PCB
(1) Open the Front Door [1], and turn the Tab [2] on
the stapler slide in the direction of the arrow to
slide the Stapler to the frontmost point.
(2) Remove the Stapler Unit. (See 2-1.)
[16]
[15]
[17]
[2]
[1]
[1]
[1]
[3]
[4]
[1]
[2]