Panasonic DP-8020P

64
Internet Fax Features
Sending Documents
 A3/Ledger Size Document Transmission
When transmitting via LAN, the transmitter is
incapable of identifying the receiver's recording
paper size capability, and thus it will not reduce
the document size during transmission.
Therefore, it is recommended that you send only
A4/Letter size documents for LAN transmission.
If a A3/Ledger size document is transmitted and
the receiver is only able to print A4/Letter size
documents, the communication will fail when the
temporary setting "A3/LEDGER EMAIL XMT" of
the Select Mode is set to its default position (ON).
2
1
5
or
If set on other
function mode.
Enter Email station(s) by any combination of the
following methods and then press .
• One-Touch (Option)
• ABBR Dialling
• Manual Number Dialling
• Directory Search Dialling
(For details, see pages 58 to 60)
SET
To send with reduction, repeat Steps 1 to 6, except in Step 4, set the "A3/LEDGER EMAIL XMT" setting to "OFF"
position.
or
(Option)
When the Select Mode "A3/LEDGER EMAIL XMT" setting is set to the "OFF" position, the transmission reduction is
according to the setting of Fax Parameter No. 141 (LAN XMT REDUCE).
A3/LEDGER EMAIL XMT = ON
:
Transmits actual document size (without reduction).
A3/LEDGER EMAIL XMT = OFF
:
Reduces A3/Ledger size document to B4 size or to A4/Letter before
transmission. (According to the Fax Parameter No. 141 (LAN XMT
REDUCE) setting, see Table.)
NOTE
1. Factory default setting for Fax Parameter No. 141 (LAN XMT REDUCE) is "Invalid".
(See page 151)