Panasonic DVD-S52S

21
RQT8512
When connecting with an HDMI cable to an amplifier, use the following settings on this
unit if you cannot set the speaker delay effect on the amplifier.
1. Press [3 4 2 1] to select an item and press [ENTER].
2. Press [3 4] to change the content and press [ENTER].
Icon examples:
Surround speaker (LS)
≥ Large: Select when the speaker supports low-frequency (under 100 Hz) reproduction.
≥ Small: Select when the speaker does not support low-frequency reproduction.
If the subwoofer is set to “No”, the front speakers will automatically be set to “Large”. (In
this case, we recommend connecting a speaker that can reproduce bass below
100 Hz.)
(Effective when playing multi-channel audio)
If either distance c or e is less than d, find the difference in the relevant table and
change to the recommended setting.
1. Press [3 4 2 1] to select an item and press [ENTER].
2. Press [3 4] to change the content and press [ENTER].
To finish the speaker setting
Press [3 4 2 1] to select “Exit” and press [ENTER].
Changing the speaker setting to suit your speakers
Speaker presence and size (a)
m s
m s
L
Exit
LS
R
SW
C
RS
0.0
0.0




(LS)(RS)

Exit
Front (L) Center Front (R)
— Surround —
Subwoofer
LS
LS
NoLarge Small
Delay time (b)
LS
RS
L
R
SW
"
!
C
: Recommended
placement
c Center speaker
e Surround speakers
Difference Setting
Approx. 34 cm (1
1
⁄10 feet)
1.0 ms
Approx. 68 cm (2
1
⁄5 feet)
2.0 ms
Approx. 102 cm (3
3
⁄10 feet)
3.0 ms
Approx. 136 cm (4
2
⁄5 feet)
4.0 ms
Approx. 170 cm (5
1
⁄2 feet)
5.0 ms
Difference Setting
Approx. 170 cm (5
1
⁄2 feet)
5.0 ms
Approx. 340 cm (11 feet) 10.0 ms
Approx. 510 cm (16
1
⁄2 feet)
15.0 ms
Changing the player settings
RQT8512-P.fm Page 21 Saturday, January 21, 2006 10:17 AM