until the desired mode appears
Description
Programming
Set to “WITH 1” for Toll Restriction in areas
where you are required to dial 1 to toll calls
(long distance).
Example:
You are required to insert a “1” before di@ling
the area code for long distance calls. .
“WITH 1” will be displayed and blink.
1. Dial (13).
“TOLL PREFIX” will be displayed.
2. Press the NEXT button.
[13] [NEXT] [SELECT] [MEMORY] [END]
3.
l-291 -348-7000
:---.area code
Set to “WITHOUT 1” in area where a “1” is
not needed.
4.
5.
Press the SELECT button to alternate
between “WITHOUT I” and ” WITH 1”
to select the desired mode.
Press the MEMORY button.
The LCD will stop blinking.
To return to the initial program mode, press
the END button.
Programming Table
See page 6-16. *
To Next Page
Loading...
