Panasonic EBL128 - 3 Access Levels; 4 Log on to the Control Unit (C.I.e.); How to Log on

7
DAILY USER´S MANUAL • EBL128 VERSION 2.2.X • DOCUMENT NUMBER: MEW01786 • REVISION: 1
3. ACCESS LEVELS
INFORMATION ONLY
BUILDING OFFICER
SERVICE PERSONNEL
H4 Present system status
H1 Perform monthly test
H1 Perform monthly test
H6 Display faults
H2 Disable or re-enable
H2 Disable or re-enable
H9 Interlocking outputs and inputs
H3 Set calendar and clock
H3 Set calendar and clock
H10 Change password
H4 Present system status
H4 Present system status
H6 Fault acknowledge
H5 Service
H7 Perform zone test
H6 FAULT Acknowledge
H9 Interlocking outputs and inputs
H7 Perform zone test
H10 Change password
H8 Maintenance
H9 Interlocking outputs and inputs
Described in this document
H10 Change password
4. LOG ON TO THE CONTROL UNIT (C.I.E.)
USER NAME
Up to ten users, 0 to 9 may be programmed. By default at delivery, three users are available:
 0 = Information only
 1 = Building officer
 2 = Service personnel
PASSWORD
Each user has a password for an access level, for example. "Information only", "Building officer" or "Service
personnel".
4.1. HOW TO LOG ON
a) Open the door. Press the button “Access”.
b) On the keypad, press 0, 1, 2 - - 8 or 9 to select a user. Press “A”.
c) Type the password for that user. (Six digits. * * * * * *)
After typing a correct password, the first option of the available menus will be displayed. This is a list in
which you can scroll.
For "0", Information only, no password is required.