Panasonic EP1260-W7

6 DISPLAY METHOD OF MASSAGE BLOCK TOTAL USE
TIME AND OPERATION TIME
Total use time
While pushing the + and the - intensity adjustment buttons simultaneously, turn on the power switch and continue to hold the
buttons for approximately 5 seconds. Release after the on/off LED lights up.
*When replacing the Main Circuit PCB, the use time is counted to zero because the use time is memorized in Main Circuit PCB.
*When pushing on/off button, the operation returns to normal mode.
Display method
Display it by utilizing LEDs of controller.
e.g. In the above case, (2
0
+2
2
+2
4
+2
6
) × 5 = (1 + 4 + 16 + 64) × 5 = 425 hours.
It is possible to indicate up to 5,115 hours.
To read the each operation function, push the following buttons after reading the total use time.
You can read the each operation function use time as the same display method of total use time.
Chart for reading each function use time
Button operation Function for reading use time LED display for confirming function
Shiatsu Shiatsu Shiatsu LED lights up
Swedish Swedish Swedish LED lights up
Kneading Kneading Kneading LED lights up
Vibration Vibration Vibration LED lights up
Tapping A Tapping A Tapping A LED lights up
Tapping B Tapping B Tapping B LED lights up
Whole back rolling Whole back rolling Whole back rolling LED lights up
Regional rolling Regional rolling Regional rolling LED lights up
10
EP1260-W7