4. After removing screws, you can remove the Micro switch,
Power source cord, Fuses, etc.
Caution when assembling
1. Hook the cord on the Power source box cover as the figure
and fix the Power source switch block with two screws.
2. Fix the Power source switch block plate with two screws so
that the cords will be stored through the ditch, and bind the
Insulated tie to the Main frame, which is bundling cords.
First fix the Power source switch, then bundle cords with
Insulated tie and install it to the Main frame.
27
EP1260-W7
To Next Page
Loading...
