Panasonic EP1285 - Installing the Massage Mechanism Block

EP1285
ORDER NO.0808U08C1
- 26 -
5.7. Installing the Massage mechanism block
1. Remove the Center cloth, and pass it through the hole of
the Massage mechanism block.
2. Move the Massage mechanism block downward rotating
the Up/down sensor board clockwise till the teeth join.
3. Install the Rail piece set right/left with three Screws each.
Caution in installing
Check if the Massage mechanism block is installed
horizontally.
* If it is not installed horizontally, it leads to the noise or
malfunction.