Panasonic EP30006

EP30006
ORDER NO.HPD0706U16C1
- 13 -
9. METHOD OF MASSAGE MECHANISM BLOCK INSTALLATION
MODE SET-UP (MANUAL SET-UP)
It is necessary to adjust the Massage mechanism block to Manual mode when installing or removing the Massage mechanism
block or adjusting the Up/down position as follows:
1. Insert the Power plug into the power source and turn on the switch of the Power source switch block.
2. While pushing the buttons of Ⅱ and Ⅳ, continue to push the On/off button for more than approximately three seconds.
Then, the buttons of Ⅱ, Ⅳ, and USER B light.
3. In ten seconds after the buttons of Ⅱ, Ⅳ, and USER B light, push the buttons as follows:①SELF PROGRAM⇒②
REGIONAL ROLL⇒③START
4. Move the Massage mechanism block pushing the buttons of POSITION and BACK INTENSITY.
5. Push the button of Stop after checking.